SAMSUNG Z Fold4 Front Protective Film, Phone Screen Protector, Display Shield, High Touch Sensitivity, Anti Scratch& Fingerprint Protection US Version, Transparent

Better Than White Stone Dome
Best screen protector install I’ve done in a long time.I followed a video instruction on YouTube, it was simple, easy, and quick. With basically no bubbles.The bubbles that were there disappeared after a day.You will have two horizontal lines from the adhesive with the initial install, however these will also disappear withing 24-48 hours.Great product, highly recommend!

Install was a challenge but results were worth the effort
Pros:-spot on fitment-stiffer film that is less susceptible to indentations and marks, most films are too soft in my opinion-dry application-includes 2 protectors, only use 1 at a time ;)Cons:-having to install a screen protector on this is top tier priced phone is just wrong, one should have been installed from the factory like the previous releases-my only real gripe is that the alignment jig and protective film should have been designed to mate at the top of the phone, its much easier to align the camera hole first when installing screen protectors-there were visible horizontal impressions (lines) near the center of the screen left from the first film you remove from the protector before installation, but they seem to go away so I didn’t count this against the product-no alcohol wipes in my kitIf you are new to installing screen protectors this might not be the easiest to work with. My only advice is that I always perform my installs in a steamy shower room to reduce the chances of dust ending up between the screen and protector (the worst)… and I’m glad I did because I had to lift this protector off many times before I got a bubble free install.

Nice, but hard to install.
It looks firm and strong but it is very hard to install. The instruction is not clear and the wipe is not good enough. I ended up wasting all the protector just trying to put them on the screen. Wish they can send me another one and I will update me review!

Difficult to install, two horizontal lines across middle as part of manufacturing; air bubbles!
Was quite surprised that my new Galaxy X Fold 4 did not have a screen protector on the front screen, unlike my Galaxy S10+. I did like that factory screen protector, as it held up well for 3 years, so I opted for this factory approved one.Installing was quite tricky, and I think I’m fairly handy. I performed the procedure in a steamy bathroom to reduce dust.There is a narrow horizontal strip you need to remove first to stick to the middle of the screen. Once this is in place, it anchors the rest of the screen so it’s all aligned. It’s a good design for installation, and the plastic alignment jig works well. The issue with this is the narrow horizontal strip is “cut” from the adjacent backing pieces, and this “cut” at the factory leaves a thin horizontal line where it separates from the other backing pieces. The result is two razor-thin horizontal lines across the middle of the protector once it’s installed, and they don’t seem to go away. It’s only visible when the screen is off. I also had a few small air bubbles that I could not squeeze out, and while annoying when the screen is off, they are not visible when the screen is on.I wish Samsung would have installed this at the factory like on earlier phones. This is a $2,000 device!I like the protection the protector offers, and it does not impede on the usability of the phone. It is a perfect fit, as you would expect. I wish the installation was easier.

There are 2 protectors, so take note of that. Still a bit too expensive for me considering that Samsung should’ve applied these for free on every Fold4!Application was easy enough but despite being careful as I can be, there were still air bubbles that wouldn’t go away no matter how much I scraped.Thankfully, they’re not visible when the screen’s on.